RDX AWD L4-2.3L Turbo (2010)
Pressure Regulating Solenoid: Service and Repair
A/T Clutch Pressure Control Solenoid Valve A and B Replacement
A/T Clutch Pressure Control Solenoid Valve A and B Replacement
1. Do the battery removal procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.
2. Remove the air cleaner See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair.
3. Remove the battery base See: Engine, Cooling and Exhaust/Engine/Service and Repair/Engine Removal.
4. Remove the spring clip (A) and the control pin (B), then separate the shift cable end (C) from the selector control lever (D).
5. Remove the nuts securing the shift cable bracket (E).
6. Check the bushing (F) in the shift cable end for proper fit and wear. If the bushing is loose or worn, replace the shift cable See: Shift Linkage/Shift
Cable/Service and Repair.
7. Disconnect the input shaft (mainshaft) speed sensor connector (A), the output shaft (countershaft) speed sensor connector (B), the transmission
fluid pressure switch B (3rd clutch) connector (C), and the ATF temperature sensor connector (D).
