RDX AWD L4-2.3L Turbo (2010)
Shift Interlock Switch: Testing and Inspection
Park Pin Switch Test
1. Connect the HDS to the DLC (A).
2. Check the Park Pin Switch signal with the HDS in the A/T data list while the shift lever is in P, and when the shift lever is shifted to any position
other than P.
NOTE: If the HDS does not communicate with the PCM, troubleshoot the DLC circuit See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Component Tests and General Diagnostics/DLC Circuit Troubleshooting.
3. Check that the park pin switch signal is OFF while the shift lever is in P, and signal is ON when the shift lever is shifted out of P.
4. If the park pin switch signal is OK, test is complete, disconnect the HDS. If the signal is incorrect, go to step 5, and test the switch signal at the
park pin switch/A/T gear position indicator panel light connector.
5. Remove the driver's console cover See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Center
Console Removal/Installation.
6. Disconnect the park pin switch/A/T gear position indicator panel light 6P connector (A).