RDX AWD L4-2.3L Turbo (2010)
7. Turn the ignition switch to LOCK (0).
8. Place the shift lever in R, then insert a 6.0 mm(0.24 in) pin (A) through the guide hole (B) on the mounting bracket, through the positioning hole,
and into the positioning hole on the shift lever bracket. Use only the 6.0 mm (0.24 in) pin.
9. Verify that the shift lever is secured in R.
10. Rotate the socket holder (A) on the shift cable (B) to place the tab (C) on the holder opposite the opening (D) in the shift cable bracket (E). Align
the holder (F) with the opening in the bracket, then slide the holder into the bracket. Install the shift cable end (G) over the mounting stud (H) by
aligning its square hole (I) with the square fitting (J) at the bottom of the stud. Rotate the holder a quarter turn until the holder stops to secure the
shift cable. Do not install the shift cable by twisting the shift cable guide (K).
