RDX AWD L4-2.3L Turbo (2010)
4. Install the mounting bracket on the new ATF cooler (C).
5. Slide the ATF cooler hoses over the ATF cooler lines until the hose ends contact the white mark (D) on the ATF cooler lines, and secure the hose
with the clips (E) at 6-8 mm (0.2-0.3 in) (F) from the hose end.
6. Secure the ATF cooler hose with the clamp (G) at the white line (H) on the hose.
7. Install the joint line and ATF cooler on the body, and install the harness clamp on the bracket.
8. Connect the ATF cooler hoses to the ATF cooler lines, and secure the hose with the clips See: Fluid Line/Hose/Service and Repair.
9. Install the bumper assembly See: Body and Frame/Bumper/Front Bumper/Service and Repair.
10. Refill the transmission with ATF See: Service and Repair/Procedures/ATF Level Check.
