RDX AWD L4-2.3L Turbo (2010)
18. Apply molybdenum grease to the hole in the bushing in the shift cable end, then install the shift cable bracket with the nuts.
19. Attach the shift cable end to the selector control lever, then insert the control pin into the selector control lever hole through the shift cable end,
and secure the control pin with the spring clip.
20. Check the connectors for rust, dirt, or oil, and clean or repair if necessary, then connect the connectors securely.
21. Install the battery base See: Engine, Cooling and Exhaust/Engine/Service and Repair/Engine Installation.
22. Install the air cleaner See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and Repair
.
23. Do the battery installation procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.
24. Turn the ignition switch to ON (II). Move the shift lever through all positions, make sure the transmission range switch follows the A/T gear
position indicator.
25. Check that the engine starts in P and N, and does not start in any other shift lever position.
26. Check that the back-up lights come on when the shift lever is in R.
27. Raise the vehicle on a lift, allow all four wheels to rotate freely, then start the engine, and check the shift lever operation.
