RDX AWD L4-2.3L Turbo (2010)
11. Attach the molding quarter seal (B) and the front seal (C) with adhesive tape to the inside face of the quarter glass.
-
First attach the molding quarter seal to the rear corner portion of the quarter glass, then attach the upper and lower portions of the seal around
the edge of the quarter glass. Be sure the upper end and lower end of the molding quarter seal contacts the front seal.
-
Be careful not to touch the seals where the adhesive will be applied.
12. Apply a light coat of glass primer along the edge of the front seal (A) and the molding quarter seal (B) as shown, then lightly wipe it off with gauze
or cheesecloth:
-
With the printed dots (C) on the quarter glass (D) as a guide, apply the glass primer to the front portion of the quarter glass.
-
Do not apply body primer to the quarter glass, and do not mix up the body primer applicator and the glass primer applicator.
-
Never touch the primed surfaces with your hands. If you do, the adhesive may not bond to the quarter glass properly, causing a leak after the
quarter glass is installed.
-
Keep water, dust, and abrasive materials away from primed surfaces.
