RDX AWD L4-2.3L Turbo (2010)
15. If you are installing a new windshield, set the windshield in the opening, and center it. Make alignment marks (A) across the windshield and the
body with a grease pencil at the four points shown. Make sure the pins (B) of both upper clips (C) contact with the edge of the body holes. Be
careful not to touch the windshield where the adhesive will be applied.
16. Remove the windshield.
17. Apply a light coat of glass primer to the windshield (A) along the edge of the rubber dams (B) and the windshield molding (C) as shown, then
lightly wipe it off with gauze or cheesecloth:
-
Apply glass primer to the molding.
-
Do not apply body primer to the windshield, and do not mix up the body primer applicator and the glass primer applicator.
-
Never touch the primed surfaces with your hands. If you do, the adhesive may not bond to the windshield properly, causing a leak after the
windshield is installed.
-
Keep water, dust, and abrasive materials away from primed surfaces.