RL V6-3.5L (2007)
Antenna, Radio: Service and Repair
AM/FM Antenna Repair
AM/FM Antenna Repair
NOTE: To make an effective repair, the broken section must not be longer than one inch.
1. Lightly rub the area around the broken section (A) with fine steel wool, then clean it with isopropyl alcohol.
2. Carefully mask above and below the broken portion of the AM/FM antenna wire (B) with cellophane tape (C).
3. Mix the silver conductive paint thoroughly. Using a small brush, apply a heavy coat of paint (A) extending about 1/8 inches on both sides of the
break. Allow 30 minutes to dry.
4. Check for continuity in the repaired wire.
5. Apply a second coat of paint in the same way. Let it dry 3 hours before removing the tape.
