RL V6-3.5L (2007)
License Plate Frame: Service and Repair
Rear License Trim Replacement
NOTE: Put on gloves to protect your hands.
1. Remove the trunk lid trim.
2. Remove the screws from the rear license trim (A).
3. From inside the trunk lid, remove the nuts securing the rear license trim (A).
4. Gently close the trunk lid, and pull the rear license trim (A) out to detach the clip, then remove the trim. Take care not to scratch the trunk lid.
5. Install the trim in the reverse order of removal, and note these items:
-
Check if the clip is damaged or stress-whitened, and if necessary, replace it with a new one.
-
Push the clip into place securely.