RL V6-3.5L (2007)
6. Remove the screws and separate the actuator (A) from the housing (B), then disconnect the side turn signal light 2P connector (C).
7. Remove the three screws and power mirror actuator (A).
Installation
8. Route the wire harness of the new actuator through the hole in the bracket and gasket.
9. Install the actuator, bracket, harness clip, and gasket in the reverse order of removal.
10. Install the new actuator terminals into the connector in the original arrangement as shown.
11. Reassemble in the reverse order of disassembly. Be careful not to break the mirror holder when reinstalling it to the actuator.
12. Reinstall the mirror assembly to the door.
13. Operate the power mirror to ensure smooth operation.
