RL V6-3.5L (2007)
10. Install the frame and drain tube in the reverse order of removal, and note these items:
-
Before installing the frame, clear the drain tubes and drain valves using compressed air.
-
When installing, tie the string that was left in the pillar to the top end of the new drain tube and pull it up into the roof.
-
Check the frame seal.
-
Clean the surface of the frame.
-
When installing the frame, first attach the rear hooks into the body holes.
-
Make sure the connectors are plugged in properly.
-
When connecting the drain tube, slide it over the frame nozzle at least 10 mm (0.39 in.).
-
Install the tube clip (A) on the drain tube (B) as shown.
-
After all parts are installed, including the headliner, do the moonroof calibration.
-
Adjust the glass position alignment.
11. Check for water leaks. Let the water run freely from a hose without a nozzle. Do not use a high-pressure spray.