RL V6-3.5L (2007)
7. Clean the caliper thoroughly; remove any rust, and check for grooves and cracks.
8. Check the brake disc for damage and cracks.
9. Mount the brake caliper piston compressor on the caliper.
10. Press in the piston with the brake caliper piston compressor so that the caliper will fit over the pads. Make sure the piston boot is in position to
prevent damaging it.
NOTE: Be careful when pressing in the piston, the brake fluid might overflow from the master cylinder's reservoir.
11. Remove the brake caliper piston compressor.
12. Apply M-77 assembly paste (P/N 08798-9010) to both sides of the pad shim (A), the back of the brake pads (B), and the other areas indicated by
the arrows. Wipe excess assembly paste off the pads. Contaminated brake discs or pads reduce stopping ability. Keep paste off the brake discs and
pads.
13. Install the brake pads correctly. Install the brake pad with the wear indicator (C) on the inside. If you are reusing the brake pads, always reinstall
the brake pads in their original positions to prevent a momentary loss of braking efficiency.
14. Install the pad spring (A). Hold the pad spring and install the pad pins (B) into the caliper from the outside to the inside of vehicle.
