RL V6-3.5L (2007)
Brake Caliper: Removal and Replacement
Rear/Removal
Rear Brake Pad Inspection and Replacement
CAUTION: Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
^
Avoid breathing dust particles.
^
Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner.
Replacement
1. Remove some brake fluid from the master cylinder.
2. Raise the rear of the vehicle, and support it with safety stands in the proper locations.
3. Remove the rear wheels.
4. Release the parking brake.
5. Remove the caliper bracket mounting bolts (A) while holding the caliper pins (B) with a wrench being careful not to damage the pin boot, and
remove the caliper (C). Check the hose and pin boots for damage and deterioration. Thoroughly clean the outside of the caliper to prevent dust and
dirt from entering inside. Support the caliper with a piece of wire so it does not hang from the brake hose.
6. Remove the pad shims (A) and brake pads (B).
7. Remove the pad retainers (A).
