RL V6-3.5L (2007)
Brake Hose/Line: Service and Repair
Brake Hose Replacement
NOTE:
^
Before reassembling, check that all parts are free of dirt and other foreign particles.
^
Replace parts with new ones whenever specified to do so.
^
Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water.
^
To prevent the brake fluid from leaking out, plug or cover the hose ends and joints with a shop towel or equivalent.
1. Replace the brake hose (A) if the hose is twisted, cracked, or leaking.
2. Disconnect the brake hose from the brake line (B) using a 10 mm flare-nut wrench (C).
3. Remove and discard the brake hose clips (A) from the brake hose (B).
4. Remove the brake hose from the knuckle.
5. Install the brake hose (A) on the damper, then install the brake hose bracket (B) with a new brake hose clip (C).
6. Connect the brake line (D) to the brake hose.
7. Install the brake hose (A) on the upper brake hose bracket (B) with a new brake hose clip (C).
