RL V6-3.5L (2007)
8. Replace the brake booster. Replacement includes checking the adjustment of the brake pedal height and the brake pedal position switch. Torque the
brake booster mounting nuts to 13 Nm (9.4 lb-ft).
NOTE:
^ * Do not overtighten the mounting nuts.
^ Be careful not to bend or damage the brake lines.*
9. Place the master cylinder on clean shop towel on your work bench, then pull out the piston from the end of the master cylinder. A small amount of
brake fluid will come out behind the piston; this is normal.
10. Remove the cup seal from the end of the master cylinder using the seal extractor (wire tie).
NOTE:
To avoid damaging the cup seal retention groove in the master cylinder, do not use a seal pick or any other metal tool to remove the cup seal.
