RL V6-3.5L (2007)
Rocker Arm Assembly: Service and Repair
Camshaft, Rocker Arm, Camshaft Seal, and Pulley Installation
Camshaft, Rocker Arm, Camshaft Seal, and Pulley Installation
1. Apply a light coat of new engine oil around the camshaft oil seal.
2. Gently tap the new camshaft oil seal (A) into the cylinder head.
-
1 Tap the camshaft oil seal in squarely.
-
2 Install the oil seal about 0.5 - 1.5 mm (0.02 - 0.06 inch) below the surface of the cylinder head.
3. Insert the camshaft (B) into the cylinder head, then install the camshaft thrust cover (C). Always use a new 0-ring (D). Apply new engine oil to the
camshaft journals and lobes.
4. Check that the oil seal lips are not distorted.
5. Install the solid dowel pins (E) and the hollow dowel pins (F).
6. Reassemble the rocker arm assembly.
7. Loosen the valve adjusting screws.
8. Set the rocker arm assembly in place, and loosely install the bolts. Make sure that the rocker arms are properly positioned on the valve stems.
