RL V6-3.5L (2007)
Valve Cover: Service and Repair
Cylinder Head Cover Installation
Cylinder Head Cover Installation
1. Check the spark plug seals for damage. If the seal is damaged, replace it.
2. Clean the head cover contacting surfaces with a shop towel.
3. Set the spark plug seals (A) on the spark plug tubes, and install the cylinder head covers (B).
4. Visually check the spark plug seals for damage.
5. Inspect the cover washers (C). Replace any washer that is damaged or deteriorated.
6. Tighten the bolts in two or three steps. In the final step tighten all bolts, in sequence, 12 Nm (1.2 kgf-m, 8.7 ft. lbs.).
