RL V6-3.5L (2007)
1. Remove the intake manifold cover.
2. Remove the air intake duct.
3. Remove the positive crankcase ventilation (PCV) hose (A), brake booster vacuum hose (B), and vacuum hose (C).
4. Remove the evaporative emission (EVAP) canister purge hose (A) and water bypass hoses (B), then plug the water bypass hoses.
5. Remove the engine wire harness connectors and wire harness clamps from the intake manifold.
^
Intake air temperature (IAT) sensor connector
^
Throttle actuator connector
^
Manifold absolute pressure (MAP) sensor connector
^
Evaporative emission (EVAP) canister purge valve connector
^
Intake manifold tuning (IMT) valve actuator connector
6. Remove the upper cover mounting bolts and nuts sequentially in two or three steps, remove the upper cover.
