RL V6-3.5L (2007)
3. Install the EVAP canister purge hose (A) and water bypass hoses (B).
4. Install the positive crankcase ventilation (PCV) hose (A), brake booster vacuum hose (B), and vacuum hose (C).
5. Connect the engine wire harness connectors, and install the wire harness clamps to the intake manifold.
^
Intake air temperature (IAT) sensor connector
^
Throttle actuator connector
^
Manifold absolute pressure (MAP) sensor connector
^
Evaporative emission (EVAP) canister purge valve connector
^
Intake manifold tuning (IMT) valve actuator connector
6. Install the intake air duct.
7. Clean up any spilled engine coolant.
8. After installation, check that all tubes, hoses, and connectors are installed correctly.
9. Install the intake manifold cover.
10. Refill the radiator with engine coolant, then bleed air from the cooling system with the heater valve open.