RL V6-3.5L (2007)
Blower Motor: Service and Repair
Blower Unit Removal/Installation
Blower Unit Removal/Installation
1. Remove the glove box housing.
2. Remove the kick panel.
3. Cut the plastic cross brace (A) in the glove box opening with diagonal cutters in the area shown. Retain plastic cross brace to be reinstalled later.
NOTE: Use the grommets (B) and the self-tapping screws by installing plastic cross brace.
4. Remove the wire harness clips (A) and the connector clips (B). Remove the bolts and the glove box frame (C).
5. Disconnect the connectors (A) from the blower motor, throttle actuator control module subharness, and dashboard wire harnesses. Remove the
connector clip (B) and the wire harness clips (C).