RL V6-3.5L (2007)
3. Remove the wheel sensor (A) from the knuckle. Do not disconnect the wheel sensor connector.
NOTE: Use new clips (B) on reassembly.
4. Remove the cotter pin (A) from the tie-rod end ball joint, then loosen the nut (B).
NOTE: During installation, install the new cotter pin after tightening the nut, and bend its end as shown.
5. Disconnect the tie-rod end ball joint from the knuckle using the ball joint remover.
6. Remove the holder (A) from the knuckle (B).
