RL V6-3.5L (2007)
Information Bus: Component Tests and General Diagnostics
Relay Control Module Input Test
Relay Control Module Input Test
1. Remove the under-hood fuse/relay box under cover.
2. Disconnect the under-hood fuse/relay box connector J (10P).
3. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 4.
4. Reconnect the connector to the under-hood fuse/relay box, and make these input tests at the connector.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, go to step 5.
5. Disconnect the under-hood fuse/relay box connector J (10P), and make these input tests at the connector.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, the relay control module must be faulty, replace the under-hood fuse/relay box.
