RL V6-3.5L (2007)
Transmission Position Switch/Sensor: Service and Repair
Transmission Range Switch Replacement
Transmission Range Switch Replacement
1. Make sure you have anti-theft codes for the audio system and navigation system (if equipped), and write down the audio presets ('05-06 models).
Make sure the ignition switch is OFF.
2. Remove the battery trim and left upper fender cover.
3. Disconnect the negative terminal from the battery, then disconnect the positive terminal.
4. Remove the battery hold-down bracket, and remove the battery and battery tray.
5. Remove the air intake duct and air cleaner housing.
6. Remove the battery base.
7. Remove the nuts securing the shift cable bracket (A).
8. Remove the spring clip/washer (B) and control pin (C), then separate the shift cable end (D) from the control lever (E). Check synthetic resin
bushing (F) in the shift cable end for a proper fit and wear. If the bushing is fitted loose or worn, replace the shift cable.
9. Disconnect the transmission range switch connector.
10. Pry the lock tab of the lock washer (A) on the control lever (B), and remove the nut (C), lock washer, spring washer (D) and control lever.
11. Pry the lock tabs of the lock washer (E) on the transmission range switch (F), hold the selector control shaft (G) with a 6.0 mm wrench, and loosen
the locknut (H).
12. Remove the locknut and lock washer, then remove the transmission range switch (two bolts).
13. Set the new transmission range switch (A) to the N position. The transmission range switch clicks in the N position, and the selector control shaft
hole (B) aligns with the N position line (C).
