RL V6-3.5L (2007)
10. Disconnect the quick-connect fitting (A): Hold the connector (B) with one hand, and squeeze the retainer tabs (C) with the other hand to release
them from the locking tabs (D). Pull the connector off.
NOTE:
-
Be careful not to damage the line (E) or other parts.
-
Do not use tools.
-
If the connector does not move, keep the retainer tabs pressed down, and alternately pull and push the connector until it comes off easily.
-
Do not remove the retainer from the line; once removed, the retainer must be replaced with a new one.
11. After disconnecting the quick-connect fitting, check it for dirt or damage.
12. Reconnect the negative cable to the battery, and do these items:
-
Power window control unit reset procedure.
-
Enter the anti-theft codes for the radio and the navigation system.
-
Steering column position memorization.
Without the HDS
1. Make sure you have the anti-theft code for the radio, and the navigation system.
2. Remove the left kick panel, then remove PGM-FI main relay 2 (FUEL PUMP) (A) from the under-dash fuse/relay box.
3. Start the engine, and let it idle until it stalls.
NOTE: If any DTCs are stored, clear and ignore them.
4. Turn the ignition switch OFF.
5. Remove the fuel fill cap.
6. Disconnect the negative cable from the battery.
