RL V6-3.5L (2007)
10. Remove the ATF joint pipes, O-rings, ATF pipe, and gasket.
11. Check the fluid passage of the solenoid valve for contamination.
12. Connect the negative battery terminal to A/T clutch pressure control solenoid valve C connector terminal No. 2, and connect the positive battery
terminal to the connector terminal No. 1. Make sure A/T clutch pressure control solenoid valve C moves.
13. Disconnect one of the battery terminals and check the valve movement at the fluid passage in the valve body mounting surface. If the valve binds
or moves sluggishly, or if the solenoid valve does not operate, replace A/T clutch pressure control solenoid valve C.
14. Clean the mounting surfaces and the fluid passages of the solenoid valve body and the transmission housing.
15. Install the 8 x 53 mm ATF joint pipe (A) with the filter side into its mounting hole (B).
16. Check the height (A) of the 8 x 53 mm ATF joint pipe (B) between the top (C) of the pipe and the solenoid valve body mounting surface (D). The
height is about 7 mm (0.3 in.) If the height is over 7 mm (0.3 in.), push the pipe until it bottoms in the accumulator body.
