RL V6-3.5L (2007)
Relay Box: Service and Repair
Passenger's Under-Dash Fuse/Relay Box
Passenger's Under-dash Fuse/Relay Box Removal/Inst
SRS components are located in this area. Review the SRS component locations and precautions and procedures before performing repairs or servicing.
Removal
1. Make sure you have the anti-theft codes for the audio and the navigation system. If equipped with XM radio, write down the XM radio presets.
2. Make sure the ignition switch is OFF.
3. Disconnect the negative battery cable, then disconnect the positive cable, and wait at least 3 minutes.
4. Remove the right front door sill trim and right kick panel.
5. Disconnect the connectors from the passenger's under-dash fuse/relay box (A).
6. Remove the mounting bolts and the passenger's under-dash fuse/relay box.
7. Carefully remove the relays by prying under the base of the relay.
NOTE: Do not use pliers. Pliers will damage the relays, which could cause the engine to stall or not start.
Installation
1. Install the passenger's under-dash fuse/relay box in the reverse order of removal.
2. Install the relays and connectors to the passenger's under-dash fuse/relay box.
3. Install the removed parts in the reverse order of removal.
4. Connect the positive cable to battery, then connect the negative cable to the battery.
5. Enter the audio and navigation system anti-theft codes, and set the clock. If the XM radio is equipped, enter the XM radio presets.
6. Confirm that all systems work properly.
