RL V6-3.5L (2007)
Air Bag Control Module: Service and Repair
Front Passenger's Weight Sensor Unit Replacement
Front Passenger's Weight Sensor Unit Replacement
NOTE: Review the seat replacement procedure before performing repair or service.
Removal
1. Slide the seat all the way to the rear.
2. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
3. Disconnect the front passenger's airbag 4P connector.
4. Disconnect the connectors from the front passenger's weight sensor unit. Remove the mounting bolt (A) and the front passenger's weight sensor
unit (B) from the seat riser.
Installation
NOTE: Be sure to install the harness wires so they are not pinched or interfering with other parts.
1. Place the new front passenger's weight sensor unit on the seat riser. Tighten the mounting bolt (A), and connect the connectors.
2. Reconnect the front passenger's airbag 4P connector.
3. Reconnect the negative cable to the battery.
4. Calibrate the front passenger's weight sensor unit.
5. After installing the front passenger's weight sensor unit, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator
should come on for about 6 seconds and then go off.
