RL V6-3.5L (2007)
Seat Occupant Sensor: Service and Repair
Front Passenger's Weight Sensor Replacement
Front Passenger's Weight Sensor Replacement
Removal
NOTE: Removal of the front passenger's weight sensors must be performed according to the precautions/procedures.
1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
2. Remove the front passenger's seat assembly.
3. Remove the cushion cover/pad from the seat cushion frame.
4. Using a TORX T27 bit, remove the tamper-resistant TORX bolts (A) attaching the seat track (B) to the weight sensors (C).
5. Disconnect the sensor connectors (D) from the seat weight sensor unit, then remove the front passenger's weight sensors.
Installation
NOTE: Be sure to install the harness wires so they are not pinched or interfering with other parts.
1. Install the new front passenger's weight sensors with TORX bolts (A) under the seat track.
2. Reassemble the front passenger's seat cushion cover/pad.
3. Reinstall the front passenger's seat.
4. Reconnect the negative cable to the battery.
5. Calibrate the front passenger's weight sensor unit.
6. After installing the front passenger's weight sensors, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should
