RL V6-3.5L (2007)
Transmission Position Switch/Sensor: Testing and Inspection
Transmission Range Switch Test
Transmission Range Switch Test
1. Make sure you have anti-theft codes for the audio system and navigation system (if equipped), and write down the audio presets ('05-06 models).
Make sure the ignition switch is OFF.
2. Remove the battery trim and left upper fender cover.
3. Disconnect the negative terminal from the battery, then disconnect the positive terminal.
4. Remove the battery hold-down bracket, and remove the battery and battery tray.
5. Remove the air intake duct and air cleaner housing.
6. Remove the battery base.
7. Disconnect the transmission range switch connector.
8. Check for continuity between the terminals at the switch connector. There should be continuity between the terminals in the following table for
each switch position.
9. The transmission range switch test is finished if the test results are OK.
If there is no continuity between any terminals, check that transmission range switch installation. If the switch installation is OK, replace the
switch.
10. Reinstall all parts removed.
11. Enter the anti-theft codes for the audio system and navigation system (if equipped) and set the clock, and enter the audio presets ('05-06 models).
