RL V6-3.5L (2007)
Power Steering Pressure Switch: Testing and Inspection
PSP Switch Signal Circuit Troubleshooting
1. Start the engine, and let it idle.
2. Align the steering wheel straight ahead.
3. Check the PSP SWITCH in the DATA LIST with the HDS.
Does it indicate ON?
YES - Go to step 4.
NO - Go to step 12.
4. Turn the steering wheel to the full lock position.
5. Check the PSP SWITCH in the DATA LIST with the HDS.
Does it change to OFF?
YES - The PSP switch signal circuit is OK.
NO - Go to step 6.
6. Disconnect the PSP switch 2P connector.
7. Check the PSP SWITCH in the DATA LIST with the HDS.
Does it change to OFF?
YES - Replace the PSP switch.
NO - Go to step 8.
8. Turn the ignition switch OFF.
9. Jump the SCS line with the HDS.
10. Disconnect PCM connector E (31P).
11. Check for continuity between PSP switch 2P connector terminal No. 1 and body ground.
Is there continuity?
YES - Repair short in the wire between the PCM (E17) and the PSP switch.
NO - Update the PCM if it does not have the latest software, or substitute a known good PCM, then recheck. If the symptom/indication goes away
with a known good PCM, replace the original PCM.
12. Turn the ignition switch OFF.
13. Disconnect the PSP switch 2P connector.
