RL V6-3.5L (2007)
23. Install the pump cover (B) in the pump housing. Torque the bolts in a criss-cross pattern in two or more steps.
24. Coat the flow control valve (A) with power steering fluid, then install it and the spring (B) in the pump housing.
25. Coat the new 19.8 mm O-ring (C) with power steering fluid, and install it on the flow control valve cap (D), then install the cap on the pump
housing, and tighten it to the specified torque.
26. Coat the new 15.8 mm O-ring (A) with power steering fluid, and install it on the inlet joint (B). Install the inlet joint on the pump housing.
27. Check that the pump turns smoothly by turning the pulley by hand. If it turns hard, loosen the four flange bolts on the cover, then retighten them in
same manner as in step 23. Turn the pump again by hand.
