RL V6-3.5L (2007)
8. Turn the steering wheel from lock-to-lock several times to warm the fluid to operating temperature.
9. Measure steady-state fluid pressure while the engine is idling. If the pump is in good condition, the gauge should read no more than 1,500 kPa
(15 kgf/cm2, 213 psi).
If it reads high, check for:
-
Clogged or deformed feed or return line between the pump and gearbox.
-
Clogged valve body unit.
10. Let the engine idle, and gradually close the shut-off valve and immediately read the pressure.
NOTICE: Do not keep the shut-off valve closed more than 5 seconds or the pump could be damaged by over-heating.
11. Immediately open the shut-off valve fully. If the pump is in good condition, the gauge should read at least 9,604-9,996 kPa (98-102 kgf/cm2,
1,392-1,448 psi). A low reading means pump output is too low for full assist. Repair or replace the pump.
