RL V6-3.5L (2007)
Steering Wheel: Service and Repair
Steering Wheel Installation
Steering Wheel Installation
1. Before installing the steering wheel, make sure the front wheels are aligned straight ahead, then center the cable reel (A). Do this by first rotating
the cable reel clockwise until it stops. Then rotate it counterclockwise about three full turns. The arrow mark (B) on the cable reel label point
should point straight up.
2. Position the two tabs (A) of the turn signal cancelling sleeve (B) as shown. Route the airbag connector through the steering wheel and install the
steering wheel on to the steering column shaft, making sure the steering wheel hub (C) engages the pins (D) of the cable reel and tabs of the turn
signal canceling sleeve. Do not tap on the steering wheel or steering column shaft when installing the steering wheel.
3. Install the steering wheel nut (A), and tighten it to the specified torque. Connect the cable reel connector. Make sure the wire harness is routed and
fastened properly.
4. Install the driver's airbag, and confirm that the system is operating properly.
5. Enter the anti-theft codes for the radio or the navigation system, then enter the audio presets. Reset the clock.
6. Check the cruise control, audio remote, navigation system, voice control, HFL, and turn signal canceling for proper operation.
