RL V6-3.5L (2007)
3. Remove the self-locking nut (E), washers (F), and the flange bolt (G), then remove the lower arm A.
4. Remove the backing plate mounting nuts (A), then remove the backing plate (B). To prevent damage to the backing plate or parking brake shoes
assembly and cable, use a short piece of wire to hang the backing plate from the undercarriage. Do not twist the parking brake cable with force.
5. Remove the wheel sensor bracket (A) from the knuckle. Do not disconnect the wheel sensor connector.
NOTE: Use a new bracket on reassembly.
6. Remove the lock pin (A) from the upper arm ball joint, then loosen the nut (B).
NOTE: During installation, install the new lock pin as shown after tightening the nut.
