RL V6-3.5L (2007)
Suspension Spring ( Coil / Leaf ): Removal and Replacement
Front Suspension
Damper/Spring Removal/Installation
NOTE: When compressing the damper spring, use a commercially available strut spring compressor (Branick MST-580A or Model 7200, or
equivalent). According to the manufacturer's instructions.
Removal
1. Remove the engine compartment covers (A).
2. Raise the front of the vehicle, and support it with safety stands in the proper locations.
3. Remove the front wheel, taking care not to scratch the caliper.
4. Remove the damper fork (A) from the damper (B) and lower arm (C) while pushing the lower arm down.
5. Disconnect the stabilizer link (D) from the lower arm.
6. Remove the 8 mm flange nuts (A) and the 10 mm flange nuts (B) from the top of the damper.
7. Remove the damper assembly (A).
NOTE:
-
Before removing the damper assembly, make a space to remove the damper assembly by rotating the steering wheel clockwise until it stops.
-
Be careful not to damage or scratch the aluminum parts. It may weaken the suspension.
