RL V6-3.5L (2007)
1. Disassemble the damper and check the all parts as shown in the Exploded View.
2. Install the damper mounting base, washer, and 10 mm nut to the damper unit.
3. Push on the damper by hand as shown.
4. Compress the damper assembly by hand, and check for smooth operation through a full stroke, both compression and extension. The damper
should extend in a smooth, continuous motion when the compression is released. If it does not (no compression or no extension), the gas is
leaking, and the damper should be replaced.
5. Check for oil leaks, abnormal noises, or binding during these tests.
Installation
1. Place a floor jack at the connecting point of lower arm B and the stabilizer link.
2. Compress the damper (A) by hand, and move it into position.
3. Loosely tighten the damper lower mounting bolt (A).
4. Loosely install the flange nuts.
