RL V6-3.5L (2007)
7. Remove and discard the valve stem (A), and the screw (B) from the tire pressure sensor (C).
NOTE: The valve stem grommet (D) might stay in the wheel; make sure you remove it.
Installation
NOTE: Use only wheels that have a "TPMS" or "PAX System" mark (A) on them.
1. Assemble the new valve stem (A), new screw (B), and the sensor-transmitter (C).
NOTE: Always use a new valve stem and new screw.
2. Before installing the tire pressure sensor, clean the mating surfaces on the sensor and the wheel.
3. Install the tire pressure sensor (A) to the wheel (B), and tighten the valve nut (C) finger tight. Make sure the pressure sensor is resting on the
wheel.