RL V6-3.5L (2007)
Fluid Pressure Sensor/Switch: Service and Repair
2nd Clutch Transmission Fluid Pressure Switch Replacement
2nd Clutch Transmission Fluid Pressure Switch Replacement
1. Make sure you have anti-theft codes for the audio system and navigation system (if equipped), and write down the audio presets ('05-06 models).
Make sure the ignition switch is OFF.
2. Remove the battery trim and left upper fender cover.
3. Disconnect the negative terminal from the battery, then disconnect the positive terminal.
4. Remove the battery hold-down bracket, and remove the battery and battery tray.
5. Remove the air intake duct and air cleaner housing.
6. Remove the bolts securing the under-hood fuse/relay box, and move the fuse/relay box.
7. Disconnect the 2nd clutch transmission fluid pressure switch connector, and remove the 2nd clutch transmission fluid pressure switch (A).
8. Make sure there is no water, oil, dust, or foreign particles inside the connector.
9. Install the new 2nd clutch transmission fluid pressure switch and a new sealing washer (B), and tighten the switch.
10. Connect the connector securely.
11. Install the air intake duct and air cleaner housing.
12. Install the battery tray, battery, and battery hold-down bracket, then connect the battery terminals.
13. Install the left upper fender cover and battery trim.
14. Enter the anti-theft codes for the audio system and navigation system (if equipped) and set the clock, and enter the audio presets ('05-06 models).
15. Do the steering column position memorization procedures.
16. Do the power window control unit reset procedure.
