RL V6-3.5L (2007)
18. Check the fluid passage of the solenoid valve for contamination.
19. Connect the negative battery terminal to A/T clutch pressure control solenoid valve A connector terminal No. 2, and connect the positive battery
terminal to the connector terminal No. 1. Make sure A/T clutch pressure control solenoid valve A moves.
20. Disconnect one of the battery terminals and check the valve movement at the fluid passage in the valve body mounting surface. If the valve binds
or moves sluggishly, or if the solenoid valve does not operate, replace A/T clutch pressure control solenoid valves A and B.
21. Clean the mounting surfaces and the fluid passages of the solenoid valve body and the solenoid valve cover.
22. Install the new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing.
Install new O-rings over the ATF pipes.
23. Install A/T clutch pressure control solenoid valves A and B.
24. Secure the harness cover with the bolt.
25. Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely.
26. Apply molybdenum grease to the bore hole of synthetic resin bushing in the shift cable end, and the shift cable end to the control lever, then insert
the control pin into the control lever hole through the shift cable end, and secure the control pin with the spring clip/washer.
27. Secure the shift cable bracket with the nuts.
28. Install the battery base.
29. Install the air intake duct and air cleaner housing.
30. Install the battery tray, battery, and battery hold-down bracket, then connect the battery terminals.
31. Install the left upper fender cover and battery trim.
32. Enter the radio and navigation anti-theft codes, then enter the radio presets, and set the clock.
33. Do the steering column position memorization procedures.
