RL V6-3.5L (2007)
Axle Shaft Assembly: Service and Repair
Front Driveshaft Disassembly
Front Driveshaft Disassembly
Special Tools Required
-
Threaded adapter, 26 x 1.5 mm 07XAC-001 030A
-
Slide hammer, 5/8 x 18 UNF, commercially available
-
Boot band pincers, Kent-Moore J-35910 or equivalent, commercially available
Inboard Joint Side
1. Remove the set ring from the inboard joint.
2. Remove the boot bands. Be careful not to damage the boot and dynamic damper.
-
If the boot band is a welded type (A), cut the boot band (B).
-
If the boot band is a double loop type (C), lift up the band end (D), then push it into the clip (E).
-
If the boot band is a low profile type (F), pinch the boot band using commercially available boot band pincers (G).
