RL V6-3.5L (2007)
7. Fit the inboard joint onto the driveshaft, and note these items:
-
Reinstall the inboard joint onto the driveshaft by aligning the marks (A) on the inboard joint and the rollers.
-
Hold the driveshaft so the inboard joint is pointing up to prevent it from falling off.
8. Adjust the inboard joint so the rollers about in the middle of the joint, bleed the excess air from the boot, then adjust the driveshaft length to these
measurements.
9. Fit the boot ends onto the driveshaft and the inboard joint, then install the new double loop band (A) onto the boot.
