RL V6-3.5L (2007)
18. Bend the band end (A) by tapping it down with a hammer.
NOTE:
-
Make sure the band and clip do not interfere with anything, and the band does not move.
-
Remove any grease remaining on the surrounding surfaces.
19. Install the boot band on the other end of the boot, and repeat steps 11 through 18.
20. Install a new locking tab type boot band on the inboard joint side of the inboard boot. Fold down the locking tabs.
21. Lightly tap on the doubled-over portions to flatten them.
Outboard Joint Side
1. Wrap the splines with vinyl tape (A) to prevent damage to the outboard boot.
2. Install a new ear clamp band (B) and the outboard boot, then remove the vinyl tape. Be careful not to damage the outboard boot.
3. Install a new stop ring in the driveshaft groove (A).
