RL V6-3.5L (2007)
8. Adjust the length of the driveshafts to these measurements, then adjust the boots to halfway between full compression and full extension. Make
sure the ends of the boots seat in the groove of the driveshaft and joint.
Left driveshaft: 480 - 485 mm (18.90 - 19.09 inch)
Right driveshaft: 515 - 520 mm (20.28 - 20.47 inch)
9. Fit the boot (A) ends onto the driveshaft (B) and outboard joint (C).
10. Close the ear portion (A) of the band with commercially available boot band pincers Kent-Moore J-35910 or equivalent (B).
11. Check the clearance between the closed ear portion of the band. If the clearance is not within the standard, close the ear portion of the band tighter.
