RL V6-3.5L (2007)
Pressure Regulating Solenoid: Service and Repair
A/T Clutch Pressure Control Solenoid Valve A and B Replacement
A/T Clutch Pressure Control Solenoid Valve A and B Replacement
1. Make sure you have anti-theft codes for the audio system and navigation system (if equipped), and write down the audio presets ('05-06 models).
Make sure the ignition switch is OFF.
2. Remove the battery trim and left upper fender cover.
3. Disconnect the negative terminal from the battery, then disconnect the positive terminal.
4. Remove the battery hold-down bracket, and remove the battery and battery tray.
5. Remove the air intake duct and air cleaner housing.
6. Remove the battery base.
7. Remove the nuts securing the shift cable bracket (A).
8. Remove the spring clip/washer (B) and control pin (C), then separate the shift cable end (D) from the control lever (E). Check synthetic resin
bushing (F) in the shift cable end for a proper fit and wear. If the bushing is fitted loose or worn, replace the shift cable.
9. Disconnect the connectors from A/T clutch pressure control solenoid valve A, B, solenoid harness, transmission range switch, ATF temperature
sensor, output shaft (countershaft) speed sensor, input shaft (mainshaft) speed sensor, 3rd clutch transmission fluid pressure switch, and 4th clutch
transmission fluid pressure switch.
10. Remove the bolt securing the harness cover (A).
11. Remove A/T clutch pressure control solenoid valves A and B, ATF pipes (C), gasket (D), and O-rings (E).
