RL V6-3.7L (2009)
Navigation Module: Service and Repair
Navigation Unit Removal/Installation
NOTE:
-
Before you replace the navigation unit, back-up the clients data using system diagnostic mode save users memory under the functional set-up. See:
Testing and Inspection/Initial Inspection and Diagnostic Overview/Navigation System Diagnostic Mode
-
If the navigation unit is replaced or disconnected, a Map Matching must be done. See: Testing and Inspection/Initial Inspection and Diagnostic
Overview/How to Troubleshoot the Navigation System
1. Turn the ignition switch to ON (II).
2. Eject the DVD from the original navigation unit. See: Service and Repair To avoid scratching or damaging the DVD, temporarily place the DVD
in a jewel case.
3. Turn the ignition switch to LOCK (0).
4. Remove the trunk trim lining. See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim Panel/Service and
Repair/Interior Trim Removal/Installation - Trunk Area
5. Remove the four screws (A) from the navigation unit brackets (B).
6. Disconnect the navigation unit connectors (C).
7. Remove the navigation unit (D).
8. Install in the reverse order of removal.
9. Turn the ignition switch to ON (II), then reinstall the client's original DVD, verifying that the DVD is free of scratches or smudges.
10. Check any official Honda service website for more service information about patches for the navigation system. Apply any prescribed patches to
the new navigation unit.
NOTE: Simply transferring the DVD from the original navigation unit to the new navigation unit does not assure the correct software for the
vehicle will be loaded into the new navigation unit. Doing the DVD transfer without doing software patches may cause the new navigation unit to
appear to be malfunctioning.
11. Enter the new navigation anti-theft code.
12. Park the vehicle outside, and do the GPS initialization. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/How to
Troubleshoot the Navigation System
13. Give the new navigation anti-theft code to the client.
