RL V6-3.7L (2009)
License Plate Frame: Service and Repair
Rear License Trim Replacement
NOTE: Put on gloves to protect your hands.
1. Remove the trunk lid trim. See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim Panel/Service and Repair/Interior Trim
Removal/Installation - Trunk Area
2. Remove the screws from the rear license trim (A).
3. From inside the trunk lid, remove the bolts and the nuts securing the rear license trim and both back-up lights (A).
4. Remove the back-up lights from both sides.
5. Gently close the trunk lid, and pull the rear license trim (A) out to detach the clip, then remove the trim. Take care not to scratch the trunk lid.
6. Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips into place securely.