RL V6-3.7L (2009)
Headliner: Service and Repair
Headliner Removal/Installation
Special Tools Required
-
KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and the precautions
and procedures See: Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair before doing repairs or service.
NOTE:
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
-
Take care not to bend or scratch the headliner.
-
Be careful not to damage the dashboard and other interior trim.
1. Remove these items:
-
A-pillar trim, both sides See: Trim Panel/Service and Repair/Pillar Trim/Interior Trim Removal/Installation - A-Pillar Trim
-
Roof console See: Console/Service and Repair/Removal and Replacement/Roof Console Replacement
-
Front individual map light See: Lighting and Horns/Map Light/Service and Repair/Front Individual Map Light Replacement
-
Rear individual map light See: Lighting and Horns/Map Light/Service and Repair/Rear Individual Map Light Test/Replacement
-
B-pillar upper trim, both sides See: Trim Panel/Service and Repair/Interior Trim Removal/Installation - B-Pillar Upper Trim
-
C-pillar trim, both sides See: Trim Panel/Service and Repair/Pillar Trim/Interior Trim Removal/Installation - C-Pillar Trim
2. From both sides, using a trim tool, release the tabs (A), then turn the sunvisor cap (B), and remove it from the bracket (C).
3. From both sides, remove the sunvisor (A) and holder (B).
-1 Remove the self-tapping ET screws.
-2 Remove the sunvisor from the body and the holder.
-3 If equipped, disconnect the vanity mirror light connector (C).
-4 Using a flat-tip screwdriver, push the hook (D), turn the holder 90 °, and then pull it out.