RL V6-3.7L (2009)
Utility Storage Compartment: Service and Repair
Utility Pocket Housing Removal/Installation
Utility Pocket Housing Removal/Installation
Special Tools Required
-
KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to scratch the trim and the panels.
1. Remove the center trim. See: Dashboard / Instrument Panel/Service and Repair/Dashboard Center Trim Removal/Installation
2. Remove the screws.
3. Gently pull out along the top of the utility pocket housing (A) to release the clips, then lower the front side down to release the pins (B) from the
select lever bracket (C).
4. Gently pull out the ambient light bulb socket (A), then remove the utility pocket housing (B).
5. Install the pocket housing in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Make sure the bulb socket is connected securely.
-
Push the clips into place securely.