RL V6-3.7L (2009)
7. Remove the gasket (A), and remove the screw and clamp (B).
8. Remove the lower cover (A).
9. Remove the three TORX screws, and separate the mirror housing (B) from the bracket (C).
10. Disassemble the mirror housing by removing the four screws, then disconnect the 2P connector (A) from the side turn signal light (B).
NOTE: Remove the screw (C) first.
11. Route a new wire harness through the hole in the bracket and the gasket in the reverse order of removal.
12. Connect the connectors to the actuator and the side turn signal light securely.
13. Install the actuator, housing, and the bracket in the reverse order of removal.