RL V6-3.7L (2009)
Sunroof / Moonroof Drain: Service and Repair
Moonroof Drain Channel Replacement
Moonroof Drain Channel Replacement
1. Remove the glass. See: Service and Repair
2. With the moonroof wrench, move both glass brackets (A) to the position where the moonroof normally tilts up, and disconnect the drain channel
rods (B) from the joint bushings (C) on both sides.
NOTE: Check the bushings for damage, and replace them if necessary.
3. Slide the drain channel (A) forward.
4. Pull the rear edge of the drain channel (A) up while pushing both clips (B), and release the channel from both hooks (C) of the drain channel slider
by pulling it rearward.
5. Remove the drain channel.
6. Install the channel in the reverse order of removal, and note these items:
-
Push the clips into place securely.
-
Check the glass position adjustment. See: Adjustments
7. Reset the moonroof control unit. See: Testing and Inspection/Programming and Relearning
8. Check for water leaks. Let the water run freely from a hose without a nozzle. Do not use a high-pressure spray.
